Removing and cleaning the supply air fan (A)

CodeDescription
ASupply air fan
BExtract air fan
1Fine filter
2Wing bolts
3Quick connector of the cable

To clean the supply air fan:

  1. Disconnect the ventilation unit from the mains electricity supply.

  2. Lift the latch to open the door of the Vallox ventilation unit.

  3. Lift the door off.

    Caution

    The door is heavy.

  4. Remove the fine filter (1). To do so, pull the fine filter out of the unit.

  5. The fan has been fastened on the mounting plate with wing bolts (2). Remove the wing bolts and lift the fan out of the unit.

  6. Disconnect the quick connector of the fan cable (3).

  7. Clean the fan. The fan blades can be cleaned with compressed air (wear protective goggles) or by brushing them gently. Do not remove or move the fan blade balancing weights.

  8. To reassemble the ventilation unit, follow the above steps in reverse order.

  9. Close the door of the unit. Ensure that the safety switch catch of the door is touching the safety switch, allowing the unit to be turned on.

  10. Plug the ventilation unit back into the mains.

  11. The fan has now been checked and cleaned.